The unit could not be simpler to use. For blood electrification, simply apply a little conductive gel to each wrist (or soak the electrode sleeves supplied in salt water), attach the electrodes to each wrist directly over the pulse points with the elasticated velcro wrist bands, and plug the electrodes into the socket below the green led on the left. (N.B. The wrist electrodes and crocodile clips have different sized sockets so it is not possible to get them confused). The on/off switch on top also adjusts the voltage supplied to the wrists in the same manner as a volume control, clockwise increases electricity, counter clockwise decreases it. The wrist electrodes are a metre in length which means they can be comfortably worn underneath a shirt, jacket or jumper and the unit can either be attached to a belt with the clip supplied or placed into a breast or side pocket. This way, the unit can be worn for extended periods of time (around 8-12 hours without recharging depending on setting) without disturbing general leisurely activities too much. A minimum of two hours a day for 6-8 weeks is Beck's recommend treatment time, however the design of his device running at 4hz means it is significantly more "hostile" to users causing toxic effects to patients taking many varieties of medications, even vitamin supplements such as garlic can cause toxicity, and smokers were unable to use the device because of the increased nicotine absorption. Our unit has been designed to cover as many eventualities as possible. Under emergency situations, it is possible to generate a batch of Ionic Colloidal Silver directly from the battery. The unit can also be used with standard 9v batteries for blood electrification but must NOT be plugged into the mains to generate ICS. To generate ICS when using a standard battery simply remove the battery before plugging into the mains socket.
To generate colloidal silver, simply insert the two pure silver wires into the foam holder approximately 25mm apart (1 inch), attach the crocodile clips to the silver and plug them into the socket below the red led on the right. Fill the glass beaker with 250ml of distilled water, suspend the silver wires in it and plug the unit into the mains supply. This will then produce an ionic silver colloid solution of 3-5 parts per million in 15-30 minutes. Distilled water is a virtual necessity for generating Ionic Colloidal Silver (ICS). Although deionised water can be used to generate ICS, it can be more difficult. For the first couple of weeks of attempting to make ICS using "purified" water purchased from the chemist, I could not understand why no chemical reaction appeared to be occurring. The reason is that genuine deionised water does not conduct electricity well enough for the electrolysis process to begin. In England I have found it impossible to purchase distilled water any longer as the process is apparently far less economical than deionising. A way around this problem can be to add a small amount of colloidal silver from a previous batch to increase the conductivity of the deionised water, however distilled is still the ideal. Since the "Electronic Alchemy Research Project" started a couple of years ago, after talking to a chemist I discovered some brands of water which claim to be deionised are not, and they DO conduct current and have the same properties as distilled water without requiring the "kick start" of adding colloidal silver. Our device has a red led to indicate current flow. When the silver electrodes are immersed into water the led will light. If the water is from a source such as a domestic tap which contains innumerable substances, then the water becomes more conductive and the led will shine brightly. If on the other hand they are immersed into deionised water, the led will barely light as the water is not conductive enough to allow the process to begin. This gives a quick and easy indication as to whether the water you are using is suitable. Our device ships with 10 litres of DISTILLED water, and anyone who benefits from ICS should seriously consider purchasing a desktop distiller (see products page). It is preferable to generate ICS from the mains as this will supply a constant current (unlike batteries) which will help to standardise your process and particle size.
Please
note: when this item is shipped outside the UK the distilled water is
not included due to weight restrictions. |
